Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New Grille Cloth Available
#16

Yeah, I was down at Kenny's last spring and the supplier messed up and he got stuck with a whole batch that was too dark. He had just developed a process where he can lighten it up and it looks pretty good. That block pattern was the most difficult to get the correct weave.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#17

Just received two pieces of Kenny's new cloth- both are outstanding.
Got a console piece of the Whiskey Rayon for a Zenith 10S567- perfect match for original
Got a piece of the small diamond pattern for a Philco 60B- very near perfect match.
High quality stuff.
#18

Icon_clapIcon_thumbupIcon_thumbup
#19

I have all of Kenny's new GC's and they are outstanding in quality and color.
#20

I just received (2 days ago) the diamond reversible pattern in the 25 x 25 to do a old Edison phonograph for a friend. It looks fantastic and the service was great. Don't hesitate. I will order from Kenny again. The owner & his wife just love it. The cloth was very close to the original piece that was still hanging on the Edison.
#21

I got some replacement griil cloth for my 40-190 console from and Etsy site: http://www.etsy.com/shop/SpeakerFabricSu...eader-name
It was not an exact match to my cat scratched and torn original, but it was close.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

[-]
Who's Online
There are currently no members online.

>