Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Diference between 45F and 45L
#1

Hi All;
Since my Philco 45 is a chassis Only..
Can anyone tell me What is the Difference between the Philco 45F and the Philco 45L ??
I know mine was not origionally a Philco 45C, as the Speaker is Not mounted on the Chassis.. My Speaker is 7.5 inches edge to edge and a 6.0 inch cone.. It looks like it was reconed, and it has only one small partial hole, probably from a small bolt..
THANK YOU Marty
#2

See http://www.philcoradio.com/assets/setindex.pdf
45F is a console model
45L is a lowboy model
#3

Hi All;
Wow, I've never seen this list..
Now I have to figure what is the difference between the Console and a lowboy.. I'll just have to look at some pictures..
THANK YOU Marty
#4

See Ron's photo gallery:
http://www.philcoradio.com/gallery/1935a.htm#v
and
http://www.philcoradio.com/gallery/1935c.htm#i
#5

Hi All;
Does Anyone have a picture of a Philco 45F Console, so I can see the Difference between an F and an L ??
THANK YOU Marty
#6

Marty, see my post just above yours.
#7

Hi All;
Thank You Klondike, You were posting Your Links at about the same Time I was asking the Question..
So, a Console is basically a LowBoy withOut Legs, Right ??
THANK YOU Marty




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for place to donate unique Philco Philco J-1930 Prototype
Thx for the description. I thought that it had to have a single 10 - 12" Sensor. Congrats on restoring the GE and...MrFixr55 — 10:12 AM
AC/DC Transformer-less Sets
Some of the original Edison DC generators were in use until the 1940s. The NYC subway and electrified Long Island Rail ...MrFixr55 — 09:39 AM
Samlex heavy-Duty bench supply filter question
I suggest sticking with the original values. Depending upon the design if you increase the cap values too much the incre...DaleHCook — 08:55 AM
AC/DC Transformer-less Sets
You’re welcome! I was born in 1995, so this is all second-hand information to me from the industry. I did some research ...jrblasde — 08:38 AM
Samlex heavy-Duty bench supply filter question
Hello Everyone, I have one of my Heavy-duty bench powersuplies made by Samlex it's 13.8 volt dc 20-25 amp supply. What I...radiorich — 11:24 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
It's a Glaser Sears changer which Philco's engineers thought was an upgrade over a VM, but in retrospect I'd prefer the ...jeibner — 10:39 PM
AC/DC Transformer-less Sets
Joseph, Thank you for the confirmation. I knew that there must be more to the Transformer-less AC/DC radios than the ...PeterN — 10:30 PM
AC/DC Transformer-less Sets
Good evening, folks. Power station engineer here! The east coast had pockets of DC-only power well into the twentieth...jrblasde — 10:11 PM
AC/DC Transformer-less Sets
Model 40 does not have a rectifier, so it would be a DC only model. This however does not say anything about using...morzh — 08:01 PM
AC/DC Transformer-less Sets
I was wondering if anyone knows if these AC/DC transformer-less sets were actually used on 110v DC anywhere, and when. ...PeterN — 06:35 PM

[-]
Who's Online
There are currently no members online.

>