Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 grill cloth
#1

Ok maybe a dumb question, but in the cutouts for the 2 outer resonators, was the pattern a V centered in the cutouts or \ in the left and / in the right?

Wondering cuz the reproduction cloth is 18" wide and the sounding board is 23 1/2" wide. Seems like if was one piece 24" wide a littler wider reproducton cloth would be nice.

John
Las Vegas, NV USA
#2

I wondered the same thing.. seems like everyone who is carrying this new design only sells 18x25.. I wonder if they make it any wider. seems like a sad oversight on their part. there are plenty of the consoles around needing TLC..
#3

Even the old stuff would not fit the 37-116 unmodified. There are Vs in both of the smaller grills.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>