Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Restoring my 37-116. It plays now!

Tom

Of course I want it! Is this something my OL gonna be OK with Icon_mrgreen Icon_lol

I recently obtained a 37-116 with the 6A5 output tubes. Reading this thread made me dig for info on the differences of the 6A5 vs the 6B4 tubes. Here is a clip from a service bulletin.
Apparently my 37-116 is a code 125-126.
Don


Attached Files Image(s)
   

Actually here in this thread on p.3. in line 3 I wrote about it.

http://philcoradio.com/phorum/showthread...718&page=3

No pot-meters for filaments and the cathodes are grounded.

Morzh I have question about your alignment, did you align your 37-116 with the metal chissis cover on or off ?

The truth is, I did not align it. The way it performs I don't really think it is misaligned.All frequencies on the dial were right where they should be so I thought, given the fact my generator is not really calibrated, I might not be doing the radio any favour by aligning it.

Most of my radios I did align but not this one. Now, I haver already forgot how it looks but I kinda doubt the cover on or off makes any difference.
Then again, if possible it is always better to align a device when it is fully assembled, thus eliminating any guesses as to whether it affects anything.




Users browsing this thread: 18 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM

[-]
Who's Online
There are currently 6837 online users. [Complete List]
» 1 Member(s) | 6836 Guest(s)
Avatar

>