Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Packard Bell Fans?
#1

Hi Guys,
I just picked up a great Packard Bell Model RPC 92. Works pretty well. I'd like to locate a service manual and/
or user manual for it. Any ideas?
Thanks!
Greg
#2

A little too new for me it date about 1969. Not listed in Sam's
Terry
#3

Thanks Terry. I would like to replace the needle on the record player but I'm not sure how to determine the record player model number? It is a Gerrard.
B
est,
Greg
#4

If this is a late 1960's Garrard record changer just about any modern magnetic cartridge can be fitted and balanced -- may be easier than obtaining a needle, but do take a close up picture which would help us determine what you have. Anything of this vintage should be gone over by a knowledgeable person to address safety and long term performance issues.
#5

If you are able to have a look at the cartridge you might be able to find a model # on it. You can use that to lookup the needle.
GL
Terry
#6

It's most likely a ceramic cartridge in a phono from that era.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2166 online users. [Complete List]
» 2 Member(s) | 2164 Guest(s)
AvatarAvatar

>