Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Is this a Philco Grandfather Clock?
#1

I spoke to the seller earlier in the week. If he still has it, I am going to look at it tomorrow as I am there on business.

What I cant tell is which model it is. Its hard to see in the pics, but the grill is different from any other Philco I can find here or online. It has two double vertical grill "slats" on each side where the ones I typically see have one on each side. The face looks a little different from a Model 570 also.

Is this authentic?

http://allentown.craigslist.org/atq/4167806101.html

Thanks,
Steve
#2

I took the photo of the front of the set and greatly turned up the luminance so I could make it out.

My vote is for a Phranken-Philco and not a legitimate, authentic set. Looks like someone combined the case of a Philco grandfather clock, the front panel of a Model 60 console, a non-original clock face (probably movement also) as well as a Model 60 chassis and speaker to make an odd combination.

--
Ron Ramirez
Ferdinand IN
#3

I tend to agree with Ron that
it's a Franken-Father.

Or if you prefer, The Odd Father of clocks.

;-)

Decent job though.

Chuck
#4

Thanks, I'll pass on it.

Steve




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5391 online users. [Complete List]
» 2 Member(s) | 5389 Guest(s)
AvatarAvatar

>