Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Bakelite cleanup
#1

I have a nice little Zenith in a bakelite cabinet, cabinet is solid but has 2 issues.

Paint dots spattered on a good portion of the top, may be oil based. I have removed these before with warm soapy water and a soft brush, not coming off this time. Suggestions?

Also kind of a gummy stuff, adhesive maybe, on a couple of spots, thinking of using Goo Gone. Anyone have any experience with that stuff.

Cabinet is brown bakelite.

Thanks.

Paul

Tubetalk1
#2

Hi Paul,

I've had good luck with paint spots on bakelite with GoJo with pumice. Once you remove the paint go over it with Novus. It should look great.

BTW, thanks for the Cab song!

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

#3

I will see if I can pick some Gojo up. You are welcome.



Paul

Tubetalk1




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>