Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My New Westinghouse
#16

Westinghouse and GE made many RCA sets through the 30's.

Paul

Tubetalk1
#17

It's a Canadian RCA Victor, made in Montreal, probably a model A-33 from around 1939-40. Canadian Westinghouse made sets with chassis of their own design, those are completely different from Canadian RCA sets in those years, the near market equivalent in the Canadian Westinghouse lineup would be an 1182X, which had five bands and motorized tuning.
Regards
Arran
#18

A very interesting set! Icon_thumbupIcon_thumbup

Agree with Brenda in that there IS a lot to DX on shortwave.

Basically, broadcast on the higher frequencies (lower wavelengths) are prevalent during the day and broadcast on the lower frequencies (higher wavelengths) are prevalent at night. Here in NC I regularly get Voice of Russia, RCI (Radio China), Radio Romania, Radio Havana. Less frequently I receive BBC, Radio Albania, Radio Teipei, and Radio Tokyo. SOMETIMES between 0100-0400 in the morning I get stations from Australia and New Zealand that broadcast vic 9MHz to 13MHz.

HOWEVER, you will find exceptions to this rule. The thing to do is tune in at different times of day on the different bands and log what you receive for future reference.

With a GOOD antenna you will also find more selections on the regular AM Broadcast band, especially at night.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM
Jackson 665 j2 schematic request
Looking for a schematic for the 665 j2 multimeter.daveone23 — 04:42 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
>>I'll write to the Henry Ford. I heard, his secretary answers his mail, not he himself.morzh — 12:15 PM
Philco 48-200 alignment questions
Just checked the power cord and I did in fact wire it so the hot side (small prong) goes to the switch.transitony — 11:52 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
Thanks for the suggestions.  I'll write to the Henry Ford.   That would certainly make sense since by the time this prod...jeibner — 11:49 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
For what it's worth, the Henry Ford Museum and Greenfield Village in Dearborn, Michigan may be an option. The obvious ...GarySP — 11:39 AM
Help with Readrite 410 tube tester
Mike and I just had a short discussion yesterday about this very subject. So often it's the connections. Ya gotta have t...RodB — 10:08 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
We have a regional museum here in the Twin Cities called The Pavek Museum. They have an extensive collection of communic...RodB — 09:30 AM
Philco 89B code 123 newbie
I did some nosing around and found that the original caps were 4 3/4" long x 1 5/16" in dia. Guess what 1"...Radioroslyn — 09:28 AM

[-]
Who's Online
There are currently 5063 online users. [Complete List]
» 1 Member(s) | 5062 Guest(s)
Avatar

>