Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-290 Escutcheon Attach Screws
#1

I'm in the process of finishing up a 41-290 and am short several of the #4 x 3/8 oval head screws that attach the dial escutcheon to the cabinet. I found some similar brass plated oval head #4 screws at Home Depot, but the diameter of the head is slightly bigger so they don't fit in the countersinks as well as the original. Any ideas as to a source for some screws that might match the originals better?

Thanks!!
#2

I found some cabinet door hinge screws that were the right size and head taper to fit the countersunk holes on my 40-201 escutcheon panel. You might look in the cabinet hinge area at your local hardware. Also, in our area I have found that Ace Hardware stores carry 5 times the amount and types of hardware compared to Lowes or Home Depot. Give them a try.

Best wishes!

Joe




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 6223 online users. [Complete List]
» 2 Member(s) | 6221 Guest(s)
AvatarAvatar

>