Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 650X shadowmeter in operation
#1

Just a short vid showing the shadowmeter in operation after repair. Thanks to Ron Ramirez for his help. This would be the same for most 36 models using the oval bezel with a shadowmeter.
http://www.youtube.com/watch?v=_2ft_zQ6pK8

-Brian
If you collect or are interested in antique telephones, please visit Classic Rotary Phones
http://www.classicrotaryphones.com/forum/index.php
#2

That is neat. I personally prefer seeing a shadowmeter vary from a very wide shadow to very narrow, as Brian's 650 does in this video, than the ones that do not vary to a great degree.

--
Ron Ramirez
Ferdinand IN
#3

If I lose the antenna, it naturally opens up very wide, yet still narrows up fairly well on a flame thrower station. The sensitivity of this sets keeps the noise floor high, hence showing less movement. I would like to get it a little bit narrower. I've thought about re-energizing the permanent magnet as stated on Chuck's site.

-Brian
If you collect or are interested in antique telephones, please visit Classic Rotary Phones
http://www.classicrotaryphones.com/forum/index.php
#4

I enjoyed the video, and as usual the next thing I know an hour has passed. From shadowmeter to radio restoration to exploding capacitors
to electrical storms to tactical nukes. I am afraid if I stay on You Tube too long I will end up watching Armageddon.

-Phil

Phil aka Philbert Q. Desenex - Twin Cities, MN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 2749 online users. [Complete List]
» 4 Member(s) | 2745 Guest(s)
AvatarAvatarAvatarAvatar

>