Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Identify This Cathedral
#1

So...I've been home from work the past two days due to illness. No fun. While trying to take it easy, I've been watching the earliest episodes of Lassie (aka Jeff's Collie) via YouTube.

The cathedral radio in the Millers' parlor puzzles me as to its manufacturer:

[Image: http://www.philcoradio.com/images/phorum..._cath1.jpg]

Close-up of same radio:

[Image: http://www.philcoradio.com/images/phorum...cath1a.jpg]

Another view:

[Image: http://www.philcoradio.com/images/phorum..._cath2.jpg]

A closer look:

[Image: http://www.philcoradio.com/images/phorum...cath2a.jpg]

Three knobs, half-moon dial, round speaker opening with cut-outs, inset panel.

What say you, folks? Jackson-Bell, maybe? Any ideas of a model number?

--
Ron Ramirez
Ferdinand IN
#2

I think we may have a winner:

http://www.radioatticarchives.com/radio.htm?radio=5419
#3

Spot on, I'd say.

"Give the Little Lady her Cupie Doll..."
#4

It looks like a Jackson Bell judging by the grille.
Regards
Arran
#5

You guys are good
#6

The grill cutouts don't look quite the same, but I believe Brenda Ann has correctly identified the set. Icon_thumbup I think Jackson-Bell cathedrals usually have variations in their grill cutouts?

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 4159 online users. [Complete List]
» 1 Member(s) | 4158 Guest(s)
Avatar

>