Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Are 40-90 and 38-12TT the same radio?
#1

http://www.ebay.com/itm/Vintage-1938-Phi...51b7e8fb98


http://www.ebay.com/itm/1940-PHILCO-MODE...4acd828333

(short of the dial - in the 38-12 the dial is from Emerson, the org one was damaged).
#2

No, they are not the same internally (although the cabinet is the same).

38-12CB is AC operated; the 40-90CB requires batteries.

38-12CB: http://www.philcoradio.com/gallery/1938c.htm#c

40-90CB: http://www.philcoradio.com/gallery/1940a.htm#e

--
Ron Ramirez
Ferdinand IN
#3

Ron

I was surprised myself as I knew that 38-12 is more or less the same as 38-15 I have only with no shortwave band. And 38-14 is close to 38-15 but is AC/DC (hot chassis).

Does it mean that the guy who listed this radio (38-12) has 40-90 chassis in it?
they look the same, those two I listed.
#4

The cabinet is the same (style), so that doesn't necessarily mean the guy's 40-90 is in a 38-12CB cabinet (although it could be). When I have a little more time, I'll take a more careful look at the auction ad.

--
Ron Ramirez
Ferdinand IN
#5

OK, just looked at both auction links, Mike. Both are 40-90CB sets. The one identified as a "38-12 TT" is a 40-90CB, and it even comes with a Silvertone Powr Shiftr battery eliminator.

And, incidentally, both have their original Philco 40-90 dials (note the large "PHILCO" near the top of each dial).

--
Ron Ramirez
Ferdinand IN
#6

Thanks Ron,

This is the answer I thought I would hear now, as after you told me there were no 38-12 with batteries, and what triggered the question in the first place was the fact that I saw the chassis being identical.....

So, given the frequency of misnomers with Philcos recently I take it it is not that rare to buy something that is in fact might be something else. However close.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! GaryGarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 4350 online users. [Complete List]
» 1 Member(s) | 4349 Guest(s)
Avatar

>