Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 89...a quick, easy question
#1

OK, from the dumb question department... the off / on / band switch on the 1935 cathedral model 89 (introduced in June of 1934)...is the first position when you turn the set on for std. broadcast band, and the second position for the police band, or is it the other way around? Thanks!

Greg V.
West Bend, WI
Member WARCI.org
#2

I don't have one but would bet the first is the broadcast band.

Gregb
#3

That's what I'm thinking too, Greg, but just wanted to verify my hunch is correct with someone who has a working example.

Greg V.
West Bend, WI
Member WARCI.org
#4

Hopefully someone who owns one will chime in and confirm.

Gregb
#5

The first click is the broadcast band. The contacts will be open on broadcast.

Steve

M R Radios   C M Tubes
#6

Thanks for the confirmation, Steve. Always helps to be on the right band when trying to pick up stations Icon_smile

Greg V.
West Bend, WI
Member WARCI.org




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently 1118 online users. [Complete List]
» 3 Member(s) | 1115 Guest(s)
AvatarAvatarAvatar

>