Thread Rating:
  • 2 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pilot H220 Radio @ Flea Market
#16

That may be difficult, it the knobs it uses are of the ship's wheel style. If those are the correct knobs they were also used on a post war Pilot TV. The good news is that you can buy reproductions of that style of knob, but they are not exactly cheap.
Regards
Arran
#17

Thanks, Arran. It does have the "ship's wheel" style knob. The outer ones are correct. I will just need to find the 2 inside ones which my friend thinks he may have. We will see.

Craig R.
#18

http://www.renovatedradios.com/parts.html

About 2/3 down the page Pilot TV-37 Television Knobs (KPilotTV37)
#19

Thanks BrendaAnnD for the link! I will wait to get the radio back and compare the knobs. From the pics in the link it looks as if we may have a match (if my chassis expert doesn't have any in his collection). Thanks again. Much appreciated!

Craig R.
#20

What is interesting is that this set is an AC/DC set with a combination of tubes in series-filament and parallel filament configuration.
#21

I just picked up one of these Pilot H220 (Similar to Model 224)
I need Back Photo's and dimensions as mine is missing.
Radio Otherwise Complete. All Original Knobs. They are NOT the Ships Wheel Type as used on the TV.
E-Mail sent to original Poster

Bob T
Wilmington, NC
#22

Looks like an Airline model.
#23

Wow! A buddy in Wilmington just got a hold of the same set!!

If you want to see something interesting look at the schematic for this bear!

11 tubes plus ballast AC/DC set, FOUR 25L6 output tubes, and TWO 25Z6 rectifiers!

When you add up the total filament voltages, it is 180 volts, AND the 81973 ballast is rated at 47 volts at 300mA!!

Some serious parallel and series filament strings here!!!
#24

Ah.... just noticed my buddy made the entry a couple before me......

Just remember, kids. Work HARDER, not SMARTER !!!
#25

    [attachment=3819][attachment=3819]        

Just Acquired a Pilot H220 (Same as 224) I believe

All original except for missing Back.
Paid a LOT more than $45 though
Needs Recap , but is playing on Variac

Have contacted OP to get Photo of back and Dimensions.
Heavy HUGE Radio

Bob T




Users browsing this thread:
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3678 online users. [Complete List]
» 1 Member(s) | 3677 Guest(s)
Avatar

>