Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1972 Pioneer model QX-4000
#1

A radio DJ friend of mine recently picked this up and asked me just to clean it up / detail the cabinet for him. He said it's a 1972 and, not knowing any better, I'll go along with that.

   
   
   
   

But what my friend doesn't have are speakers for it with the plug connectors needed for this receiver. Or just the connector ends themselves. Does anyone know a source for these?

   

Greg V.
West Bend, WI
Member WARCI.org
#2

Those are common Cinch-Jones two prong connectors. Available at pretty much any electronics wholesaler.

1972 seems a bit early, but can't say for sure. I know we started selling quad gear in 1973-74 (Fisher) at the shop I worked at.
#3

Fisher's first 4-channel receiver, model 701, was a 1971 model (introduced fall '70) according to a 1971 Fisher catalog I have.

--
Ron Ramirez
Ferdinand IN
#4

I guess being a small town business, we were a little behind the curve.
#5

Thanks for the information, Brenda & Ron. I know my friend will be glad to know. So I need to search for some Cinch-Jones two prong connectors. Do you think Radio Shack would stock these yet? We have one of those in town here.

Greg V.
West Bend, WI
Member WARCI.org




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>