Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sparton 811 finished
#1

I have had this radio for about a year and finally got the cabinet finished. I started out getting the radio working by replacing all the caps and alignment.. It is a ten tube radio and sounds very good. After I finished the cabinet I installed the chassis and found that it would turn on and I could tube in a station and then it would fade out .
I did check all the tubes and they were good.. I had installed a phono jack [for an MP3] and it worked fine
I checked the tubes again and found a 6K7 had shorted out. Once I replaced it,,, all was good.. Quite a relief.
Here are some photos of the finished cabinet


Attached Files Image(s)
                   
#2

It looks horrible! Icon_thumbdown

Quickly! Send it to my house and I will hide it in my library for no one to see...Icon_mrgreen

Ok sarcasm overIcon_lol

That is friggin beautiful. Amazing patters and you didnt kill them with darkness.

A+ Icon_thumbup

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#3

Beautiful work!.. That set will end up being a family heirloom. It's a keeper. Congrats on some mighty fine work.

The artist formerly known as Puhpow! 8)
#4

Yes, looks like some 18 century inlaid furniture, certainly no threat someone putting it at the curb.
#5

Very purdy, these types of cabinets reek of dignity and class. They really make a statement. Gorgeous...


Paul

Tubetalk1




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently no members online.

>