Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Radiola 18
#1

Could someone please let me know where the antenna hooks up to on a radiola 18 ar936? I finally received the ux280 tube and everything powers up but I don't even hear a chirp. I'm about ready to throw the towel in on this thing
#2

There should be a marked antenna post somewhere on the thing. Also, look at the back of the cabinet, might be marked 'ANT' near a hole on the back to give you a clue.

No matter where you go, there you are.
#3

Radiola 18's don't have antenna posts. They have two wires coming out from the right hand side of the main chassis. These connect directly to the chassis ground and to the input of the 1st RF amp with a resistor across them. If I get a chance, I'll take a pic of one of my chassis' later today and post it for you.
#4

I was remembering a different TRF chassis (a Steinite, I believe). It is much the same, however, with the 18 chassis. The antenna and ground wires come in on the far left side of the chassis, and run up to connect into the volume control. See pics below:

   

   

   
#5

Thank you very much. Those definitely help. The schematic I found had the speaker wired up to there!
#6

Eek... the speaker plugs into the two pin jacks on the power supply chassis.
#7

Here's an accurate schematic:

http://www.nostalgiaair.org/PagesByModel...040317.pdf

Note it shows both the DC (top) version and the AC (bottom) version. You'll see the volume control labeled as such on the DC version, on the AC version it's in the same place but not labeled.

The following document might help you also, it has voltages, component values, and tips on the 18:

http://www.nostalgiaair.org/References/A...la18-2.htm

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#8

Are those jacks hopefully 3.5mm like headphone jacks or a bit bigger?
#9

Those are for pin jacks, like they used on old headphones and speakers. Mouser sells them:

http://www.mouser.com/ProductDetail/Keys...toqrxdU%3d

So does Radiodaze as the SPC-TIP:

http://www.radiodaze.com/product/400.aspx

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#10

Thanks Brenda! She fired right up and gave a great sound! Have to do some work on the volume control though. Also thanks John, I ordered a set!
#11

Goes to show you how long it's been since I have looked at a Radiola 17 or 18. Used to be common as dirt around here.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
Hello murf! I merged the threads. Please do not start new threads regarding the same radio. Take care, - GaryGarySP — 10:21 PM
Philco 42-345 Restoration/Repair
Regarding picture 5 on page 1 of this thread this capacitor is #40 on scematics diagram - 4mF+4mF. Black wire is "-...Vlad95 — 09:01 PM
Philco 42-345 Restoration/Repair
That's a dual 4 MFD, red and green are both 4mfd and black is common negative. You should be able to see them in the pow...RodB — 08:58 PM
Philco 42-345 Restoration/Repair
Can anyone help me figure out a capacitor that has 3 wires coming out of it red and green on one side and a black wire o...osanders0311 — 08:14 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM
Philco model 38 code 121 not receiving signal.
You should be able to inject an audio signal such as from a CD or mP3into the radio at the volume control. The set will...MrFixr55 — 08:14 PM
Testing a speaker and output transformer Trutone A2-G
Hello guy's, Have a Trutone A2-G teledial floor model radio that I am having issues with. Suspecting maybe speaker or ...murf — 03:25 PM

[-]
Who's Online
There are currently 1657 online users. [Complete List]
» 1 Member(s) | 1656 Guest(s)
Avatar

>