Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Can someone tell me where to find a schematic..
#1

For this little Automatic Radio "Tom Thumb"?

I've found several "Tom Thumb" models in Nostalgia Air, but none seem to match.

   
#2

Try this schematic:
http://www.nostalgiaair.org/Resources/828/M0001828.htm

Carl
Northern Panhandle, WV
#3

Yup that is the same schematic as radiomuseum.org has posted for this radio.
BTW Brenda are you really in south Korea? Is it tough finding antique radios there?
#4

Not tough, impossible. Anything made before WWII has been long gone, pretty much nothing existed here after WWII through the Korean War. And not that much before WWII, because of the Japanese occupation. All there is here is the rare occasional set that made it's way here from Burma or some really rare ones from Europe. Everything now isn't worth owning, just solid state cheap garbage, most of which ends up at the curbside recycler after a year or two. I get all my radios from the US and Canada, mostly via ebay.
#5

Brenda, it really begs the question "are there any other radio collectors in South Korea"? You must have the largest collection over there! Nice to have your help on those pesky radio questions.
Best, Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#6

There are a few others. One is a good friend of mine, and he has over 400 radios in his collection (and a lot of money.. he was head of veterinary medicine at a large university here).
#7

Brenda ,
There is a 1947 Tom Thumb Portable for sale on E-Bay right now with a copy of the Photo-fact.Maybe the seller would copy it for you.

http://www.ebay.com/itm/1947-Tom-Thumb-P...338f02f3e3

Good Luck,
Henry
#8

I looked through all my '47 Sams, & never found a Tom Thumb listed.
According to the index, no photofact was made. May be that there
was one for '48 or 49, but when did the Mfgr. quit production??
On that note, what Co. made these units?
Jim
#9

Brenda, I have the Sams for your radio. I can scan and send it or I can mail you a copy. Which would you like?
#10

Finally found it---13-4. Is that the one you have, Jim?
It was out of place.
#11

Set 23. Maybe shown as 4713-4.
#12

Yes, that's it.
#13

Paging Brenda.
#14

Darn pager.... I must have let the battery go down. (@)@)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 3071 online users. [Complete List]
» 1 Member(s) | 3070 Guest(s)
Avatar

>