Posts: 811
Threads: 43
Joined: Dec 2008
City: Chicago, IL
The Philco Safari was introduction in 1960 as the world's first transistorized battery power portable TV.
I'd seen a few of these over the years but always too expensive or in poor condition. Finally, I got an ebay email alert about this one with a BIN of only $80 and I pounced on it.
[Image: https://farm3.staticflickr.com/2935/1421...19ff_z.jpg]
The only minor issue was a detached handle that just needed to be screwed back on.
[Image: https://farm6.staticflickr.com/5193/1423...22ea_z.jpg]
The battery is long gone, but you can also run these directly off AC. The seller claimed it worked so after an inspection inside, I went for it.
[Image: https://farm6.staticflickr.com/5319/1421...e543_z.jpg] [Image: https://farm3.staticflickr.com/2927/1423...95bc_z.jpg]
Bingo! It really does work  The image is quite bright and difficult to photograph.
[Image: https://farm3.staticflickr.com/2921/1421...6582_z.jpg] [Image: https://farm6.staticflickr.com/5079/1402...2e89_z.jpg]
It's strange how the image appears larger the further away you are.
[Image: https://farm6.staticflickr.com/5320/1418...2984_z.jpg] [Image: https://farm6.staticflickr.com/5510/1423...f057_z.jpg]
Here it is after a bit of cleaning.
[Image: https://farm6.staticflickr.com/5076/1402...ee3f_z.jpg]
I don't think it will be my new 'daily driver', but it's a neat piece of history to own.
[Image: https://farm6.staticflickr.com/5581/1419...2d6d_z.jpg]
Posts: 2,573
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
way cool congrats 
Posts: 1,106
Threads: 88
Joined: Jun 2011
City: Tacoma
State, Province, Country: Washington
Watching from four feet away, the picture is supposed to pretty much cover the entire surface area of the front screen. It almost looks like yours is missing that front glass.
Posts: 13
Threads: 2
Joined: Feb 2014
City: Columbia, MO
Nice find and price Bob. That one's on my list, as well. Looks like it produces a nice pic. Like most vintage sets, that cleaned up real nice!
Posts: 811
Threads: 43
Joined: Dec 2008
City: Chicago, IL
Nope, the glass is there. The screen is wider than 4:3 format, so I don't really see how the image could cover it all unless the top and bottom get cut off ?
[Image: https://farm3.staticflickr.com/2931/1402...c66c_z.jpg]
Posts: 13
Threads: 2
Joined: Feb 2014
City: Columbia, MO
Yes, that is right. I have a buddy, fellow TV collector who has one mint- bought new by a family member. It looks like your pix. I don't think you should expect a 16x9 flat screen look, mirror or not. Pretty sure that wasn't even a consumer product concept in the late 50's. Only in the movie theater back then.
Posts: 5
Threads: 0
Joined: Jun 2014
City: Rodengo Saiano
amazing and cute little set!
Posts: 1,468
Threads: 97
Joined: Jul 2012
City: Poughkeepsie, N.Y.
No I have seen everything! Never saw that portable before. Really cool!
Posts: 479
Threads: 73
Joined: Mar 2012
City: Riverside, CA
I saw your YouTube video on this, great find Bob. And for $80- you can't go wrong.
Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY
WoW! I'd be looking to do a Recap job at least for long term reliability. Too bad there is little current progam material worth watching.
Posts: 289
Threads: 42
Joined: Jan 2014
City: Jeffersonville
State, Province, Country: PA
Posts: 811
Threads: 43
Joined: Dec 2008
City: Chicago, IL
Sure, I'll do a full recap someday. As for current programming, there aren't any more NTSC broadcasts so many vintage TV collectors setup their own low power transmitters. I hook mine up to a DVD player or YouTube and play whatever I like
Posts: 1,114
Threads: 14
Joined: Feb 2013
City: Irvington, NY
It is quite remarkable that most of these Safari's are still operating on all their original parts 55 years later.
I have one I bought a few years ago, and it still works fine, never having been repaired or restored. Even all the electrolytics are original. Perhaps because most of the circuitry runs on on low voltages, the condition of these caps is less critical. Other than the electrolytics, most of the other caps are disc ceramics not subject to deterioration. I plan on leaving mine as is until I see any degradation in performance.
Posts: 1,106
Threads: 88
Joined: Jun 2011
City: Tacoma
State, Province, Country: Washington
One primary thing would be that back when these sets were still in general use, there wasn't as much TV to watch and/or people didn't watch as much as they do now. Especially when they were out and about. People used to go camping and to the beach to do other things besides watch television, so these didn't get a lot of use back when they were still new-ish. Ergo, things like the CRT didn't get worn out before they got put into storage in the back of someone's closet or where ever. Worst thing was that folks didn't remove the batteries first.
Posts: 4,864
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
The main issue with early solid state devices is the small electrolytic caps drying out with age more so then leakage, this is something that is more dependent on how the device is stored then how much it is used. On occasion, especially with 1960s era solid state devices, you can end up with leakage between the elements, instability, and even tin whiskers causing shorts, though I haven't heard of that being a problem with these TVs as yet. The other killer, as Brenda mentioned, is battery leakage, but that goes for battery powered tube stuff as well.
Regards
Arran
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Refinishing Ideas
|
| Hi Poulsbobl,
I think that you could get away with it. In the Philco Library, there is a parts listand specs for sp...MrFixr55 — 11:54 PM |
|
Philco 46-480 Electronic Restoration
|
| The sleeving for the transformer arrived early, so I went ahead and finished reassembling. The chassis looks far better ...jrblasde — 10:15 PM |
|
Philco 610B oscillator wiring
|
| I don't know what you are referring to when you say "tube cathode ground". Ground is a connection to the chass...RodB — 05:56 PM |
|
Zenith H725
|
| Good points, Arran. I haven't encountered this problem with any other radio (all earlier vintages), so am learning here....EdHolland — 05:32 PM |
|
Zenith H725
|
| Ed;
One thing that I will say about these is that Brand Z was considerate enough to make these mica caps easily acces...Arran — 02:34 PM |
|
Philco 610B oscillator wiring
|
| Do you know what run # your chassis is?
It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM |
|
Need to purchase some accessories for restoration of my Old Philco Radio
|
| COLLEAGUES,
Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM |
|
Zenith H725
|
| Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM |
|
Zenith H725
|
| IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM |
|
My Philco 37-116 Restore
|
| Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM |
|
Who's Online
|
There are currently 950 online users. [Complete List]
» 2 Member(s) | 948 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
