Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 70
#1

I fell into a good deal today and acquired a Philco Model 70 and need some expertise. All the 70 models that I see are pretty much a cathedral style, but this piece that I acquired is not. The electronics in this cabinet are a Philco Model 70. The cabinet however does not look like anything I have been able to find on the web. My question to you Philco experts, is this an original style cabinet? Is it even a Philco style cabinet? I am under the impression that the electronics were somewhere along the line transferred into this cabinet.

Here are some pictures of this deal that I got.

http://www.geocities.com/konen3/frontview.jpg

http://www.geocities.com/konen3/rear.jpg

Any help would be greatly appreciated.
#2

Hi

That cabinet is, most definitely, not original. Most likely homemade, although someone went to a lot of trouble to try and make it appear factory-built.

--
Ron Ramirez
Ferdinand IN
#3

Still kind of a neat cabinet, though.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4256 online users. [Complete List]
» 1 Member(s) | 4255 Guest(s)
Avatar

>