Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help with radio problem
#1

Hi all, I hope someone will be able to help me here. I have a Philco model 91L, type 127. It's a low boy console. I recapped, checked resistors, etc. about twenty years ago. Anyway, I had it on the other night and suddenly the audio just stopped. I turned it off and back on and it seemed fine for about 15 minutes. The audio just stopped again; while going over to the radio, I noticed a blue/purple glow from the back of it. There was no odor at all nor did I hear any arcing or the such. I removed the chassis today and gave it a very close visual inspection which showed nothing at all. I'm afraid to turn it back on as I may do damage to it. Does anyone know what may cause this problem? Any help would be greatly appreciated.
#2

Hi Tim,
Just a guess but I think I would look for a gassy tube in the audio section. My guess would be in the first amplifier. They produce a blue or purple glow when this happens. I don't think it would hurt to bring it up to look for it if you had some kind of limiting device such as a variac or a dim bulb tester. Good luck Icon_biggrin

Terry
#3

If the high voltage is drawing too much current, the rectifier tube will often glow purple.

Your problem could be almost anywhere. I would pull and reinsert each tube to see if the purple goes away. That might get you to the circuit. Old components tend to break down over the years and develop leakage at high voltage.

If you get really desperate, I'm over here near Morristown and available most of the time. Parts, tubes, and equipment are here too.

Pete AI2V




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Hippo 46-420 Schematic doesn't match parts list.
Here you have the part in the sch with values. I am not sure what else is needed.morzh — 02:56 PM
Restoring Philco 37-604C
Ron Here are the two of my jigs side by side. They have been with me about the same time (a couple of month differenc...morzh — 02:05 PM
Kurt P
Terry, gotcha, thanks for the clarification.  That’s probably why the speaker seems shorted.  Assuming the OT/FC/speaker...Kurt P — 10:59 AM
Radiola 18 Amplifier & PS
I have the 2.25V and 2.5V information confused, and must look more carefully at the schematic and Hammond transformer in...TN Allen — 10:24 AM
Radiola 18 Amplifier & PS
Thank you for the information, it all helps, although understanding some of it takes time. One reason for doing the PS a...TN Allen — 09:42 AM
462ron
Hi Mike, the radio is coming along nicely but wow, you must have some serious moisture in your shop judging by the amoun...462ron — 06:29 AM
Restoring Philco 37-604C
Have rebuilt the can. The can had 4 caps in it, 2x16uF, 10uF and 8uF. I used a 15uF as the first cap, 22uF and 10uF ...morzh — 09:38 PM
Philco 89B code 123 newbie
The flat copper wires are from the hum bucking coil. All of the other resistances seem to be OK.Radioroslyn — 04:15 PM
Help with weston 669
I need help with my 669 meter. I recapped it becausing it was pegging the meter out. Now the neon light comes on (not su...daveone23 — 02:42 PM
Philco 89B code 123 newbie
I may be incorrect but you should measure around few ohms for the voice coil. In addition you may have a hum bucking coi...RodB — 02:29 PM

[-]
Who's Online
There are currently 4463 online users. [Complete List]
» 1 Member(s) | 4462 Guest(s)
Avatar

>