Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 70
#1

I fell into a good deal today and acquired a Philco Model 70 and need some expertise. All the 70 models that I see are pretty much a cathedral style, but this piece that I acquired is not. The electronics in this cabinet are a Philco Model 70. The cabinet however does not look like anything I have been able to find on the web. My question to you Philco experts, is this an original style cabinet? Is it even a Philco style cabinet? I am under the impression that the electronics were somewhere along the line transferred into this cabinet.

Here are some pictures of this deal that I got.

http://www.geocities.com/konen3/frontview.jpg

http://www.geocities.com/konen3/rear.jpg

Any help would be greatly appreciated.
#2

Hi

That cabinet is, most definitely, not original. Most likely homemade, although someone went to a lot of trouble to try and make it appear factory-built.

--
Ron Ramirez
Ferdinand IN
#3

Still kind of a neat cabinet, though.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5330 online users. [Complete List]
» 1 Member(s) | 5329 Guest(s)
Avatar

>