Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Question on replacing the selenium rectifier in my tube checker
#1

Hey gang, I have a heathkit TC-2 tube checker. I have replaced the caps and some off spec resistors. It has a selenium rectifier which id like to replace, its on the secondary of the Xfmr. My question is must I use a resistor in series with a new diode? I have hooked it up with test leads (1N5401) and it works OK without any resistance added, I am able to zero the meter and have some left on the trim pot. If I add a 100ohm i need to turn the pot full on to get the meter up to zero position.
I replaced one of these on my VTVM and had to use a resistor to drop the voltage but it was on the primary.....not sure what to do here....
The schematic shows a silicon diode symbol. Any ideas?

[Image: http://i818.photobucket.com/albums/zz105...bc3634.gif]
#2

My guess is, no you do not absolutely have to.
#3

well, I put it in and all my readings are higher than used to be. I may just well nedd to add a small bit of resistance but im gonna leave it alone for now.
#4

I think you are OK, incoming line voltage is a bit higher now. Could add a fuse or little fusister if you want.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM
12' Philco
Not anymore Mike. Andre The Giant Born: May 19, 1946, Coulommiers, France Died: Jan 28, 1993 (46 years), Paris, Fran...RodB — 11:53 PM
IF can wire size and Rubber mounts?
Renovated Radios do carry what you need. As for the voltage, a wire should be at least 300V-rated.morzh — 11:13 PM
12' Philco
Andre the Giant got 2" on Kareem :lol:morzh — 11:11 PM
IF can wire size and Rubber mounts?
Thanks for the info but I doubt that a hardware store would be carrying the proper tuner assembly support mountings for ...georgetownjohn — 10:38 PM
12' Philco
Perhaps Kareem Abdul Jabbar?GarySP — 10:33 PM
My last cabinet for this year
Outstanding work, Dan! Take care and BE HEALTHY! GaryGarySP — 10:31 PM
My last cabinet for this year
They are a nice looking radio, Stromberg. I have a small tabletop octagon-dial one. It sounds surprisingly nice. And t...morzh — 09:40 PM
Philco 41-608 changer coupler
Different years but the same idea.morzh — 09:38 PM

[-]
Who's Online
There are currently no members online.

>