1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
DeWald J-802 Schematic
Eric Adams
Phorum Expert
*****
Posts: 825
Threads: 113
Joined: Aug 2012
City: The Villages State, Province, Country: Florida
#1

09-06-2014, 12:18 AM
Does anyone know where I can get a schematic for this DeWald? It is not an 802 and not a J-800.
The tube line-up is:35L6GT,12AL5,12AU6,12BA6,12BA6,12AT7,12AV6.

Thanks
Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

Website Find
Arran
Phorum Expert
*****
Posts: 4,657
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#2

09-06-2014, 01:56 AM
Does this set use a selenium rectifier? Assuming that the tube lineup is correct? I'm guessing that it's a transformerless AM/FM set ( I do not want to say AC/DC in case they used a doubler).
Regards
Arran
Find
Eric Adams
Phorum Expert
*****
Posts: 825
Threads: 113
Joined: Aug 2012
City: The Villages State, Province, Country: Florida
#3

09-06-2014, 08:40 AM
That's the one Arran! Do you know where I can get a schematic?
Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

Website Find
Radioroslyn
Phorum Expert
*****
Posts: 7,273
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#4

09-08-2014, 05:03 PM
If it is built after 1946 it maybe in Sam's Photofacts. Don't have my index handy.
Terry
Find
Arran
Phorum Expert
*****
Posts: 4,657
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#5

09-09-2014, 10:22 PM
I have some Beitmans books, I will check in those when I get a chance, it looks familiar so I may have seen it whilst flicking through one of them.
Regards
Arran
Find
Eric Adams
Phorum Expert
*****
Posts: 825
Threads: 113
Joined: Aug 2012
City: The Villages State, Province, Country: Florida
#6

09-09-2014, 11:31 PM
Thanks Arran.
Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

Website Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3437 online users. [Complete List]
» 1 Member(s) | 3436 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)