Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help with proper verbage of a part...
#1

The plastic piece that the electric cord passes through and protects it from the chassis...and does Radio Shack have those?
#2

Could be a grommet or a clamp if it actually holds the wire too. Radio shack used to carry them but not sure if they do anymore. Worth a try I spose.
#3

Except Radio Shack stores are no longer brick and mortar, or almost so. Online possibly, but these things are not hobbyist exclsively and could be sold in hardware stores, or in Lowes/Home Depot.
#4

Also sold by Mouser.
#5

As far as a term for it I think it may be called a 'line restraint'. I don't know if any suppliers call it that Icon_smile Also "Heyco Bushing" relating to a major manufacturer of them.
#6

Thanks all! That helped!
#7

"Strain relief" is another term that's used.
Keith
#8

Grommet
#9

Lowes has them in drawers in the hardware section, they sell grommets too.
#10

Radio Daze sells those strain relief pieces also.
#11

Well the old timers often called an unidentified part a framis. Plural is framae. Indeed the crimp imposed by these little things caused many a cord to fail, but not that many fires. So they used 'em and still do with very few lawsuits.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>