Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Speaker Identification
#1

I purchased a small lot today which included a Philco speaker.Appx 8 1/2 inches diagnally across the mounting holes. The output transformer is stamped 2580N and 11-34 is stamped under that. There is a red stamp on the field coil but it is very faded. It looks like K or R 22. It has a 4 pin round plug with a flat on one side and with 3 wires. Can anyone tell me the model it belongs to?
Thanks,
Henry
#2

Using the handy-dandy "Philco Speakers" Excel file available here:
http://www.philcoradio.com/phorum/showth...hp?tid=215

I find that you probably have a K-22 speaker. It has a 2580 single-ended output transformer. 1125 ohm field, rated at 65 mA current.

Intended for use with model 44B, it could also be used with a 19B, 89, or any 1932-36 Philco requiring an 1125 ohm field. You would have to replace the audio output transformer to use it with a Philco requiring a push-pull output.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron.
Henry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently 2780 online users. [Complete List]
» 2 Member(s) | 2778 Guest(s)
AvatarAvatar

>