Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

SW aerial
#16

Never tried 75ohm on short wave receiver. To transmit you need RG58 ie 2 meter band to Hf bands. Have used single long wire to receive also 300 ohm or 400 ohm ladder lead with diapole ant. For 300 ohm twin lead try amazon.com cost around 15 dollars for 100 feet. David
#17

ARRL Ant book now cost $50 not on my budget. Found another Ant book as a free pdf download looks to have lots of good info. May be over the top for just wanting to receive but a good read. David http://www.apparentlyapparel.com/uploads...n_carr.pdf
#18

So, finally, It is done. 20 ft above the grade, 60 ft in total length, 2 pieces at 30 ft each coming to the central insulator, connected to the coax, one end to the center, another to the shield. At the set- tried the center wire to the "A", shield to the "G". Reception is poor, worse, than 15 ft straight wire. When both (center and shield) connected together just before connecting to "A"- reception is as good as my 25 ft wire hanging on the bush, albeit the stations coming in quite louder.But selection is still the same.Is anything wrong? I have been getting plenty of stations prior to that, but thought the new contraption will provide even better results.
#19

Glad you have the ant up and running. Something to consider is time of day if I want to listen to OZ get up at 430 AM make coffee turn on short wave have a 2-3 hour window then signal is gone. Another thing just not that much out there to listen to the BBC does not send a signal to North America they are hard to find. Best time for listening is at night. Living in Fl. There is always Radio Havana some of there stuff is in english. Try the ham bands most signals SSB their are a few nets using AM. Also at night try AM band still a few high power stations out there. David
#20

I have a long copper wire the length of my house in the attic, its about 70 feet long. I am able to pick up everything that is on at the times I listen. Great, simple, cheap antenna.
#21

I pick up plenty if not more. Albeit not sure it is "everything". Hence larger, taller antenna has been installed.
Yet, the amount of stations stays the same as with a simple long wire.
#22

That is what is to be expected. What stations you receive will be more dependent on propagation conditions rather than the antenna. If the conditions of the ionosphere are not favorable you will get no long distance reception at all. A good antenna will increase the received signal strength, but it cannot provide reception if the signal is not there in the first place.
#23

Out in the work shop turned on my SX-130 to see what was out there just after 12 noon 9-19-14 was going thur the ham band on 40 meters found a net that I was able to listen to for 30-35 minutes keep fading in out every 5 minutes. The frequency was 7.251 mhz ssb. Total lost of singal around 12.40PM. My receiver is analog looked up ther frequiency on the internet. First time listening to these guys will try tomorrow just never know what you will hear. Ant 20 feet of wire about 15 feet above the ground my location 184 feet above sea level. David




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM
38-10T chassis Restoration begins
I have a question about the mica sheets. I thought I saw somewhere on the Phorum where someone used thin plastic report ...dconant — 10:44 AM
38-10T chassis Restoration begins
Yes, you should carefully remove the mica sheets from the trimmers otherwise you risk trapping foreign material in the t...RodB — 10:34 AM
American Bosch Model 802 auto radio
Hi Joe, Thank you again. The American Bosch Model 634A has the same tube lineup as my Model 802 and the parts layout dia...Antipodal — 03:09 AM
38-10T chassis Restoration begins
hello everyone, I know it has been a while since I have posted about this radio but finally got chance work on it . I ...radiorich — 02:45 AM
Rusty Tuning Condenser
You could soak the fins in vinegar. You have to be careful if any pot metal is involved because the vinegar will dissolv...RodB — 09:20 PM
Rusty Tuning Condenser
Hello, I have a Philco 91 where the tuning condenser fins are rusty. I magnet sticks to them so they can't be aluminium....dconant — 05:50 PM
American Bosch Model 802 auto radio
I’ve found six United Bosch auto radio’s with the same 6-tube line-up as the 802, on NostalgiaAir. They are models 150, ...Joe Rossi — 02:52 PM

[-]
Who's Online
There are currently 3623 online users. [Complete List]
» 4 Member(s) | 3619 Guest(s)
AvatarAvatarAvatarAvatar

>