Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model ID Please?
#1

I've looked through the 30's lineups and cannot find this set. Help anyone?
Thanks!


Attached Files Image(s)
   
#2

That is not a Philco. Looks like a Majestic?

(since this isn't a Philco, I have moved this topic to Other Radios (Non-Philco).

--
Ron Ramirez
Ferdinand IN
#3

(09-24-2014, 08:47 PM)Ron Ramirez Wrote:  That is not a Philco. Looks like a Majestic?

(since this isn't a Philco, I have moved this topic to Other Radios (Non-Philco).

Thanks, Ron....... no wonder I couldn't find it! The person selling this thought it was a Philco, but I was interested mostly from the condition.
I'll check at the radiomuseum site under Majestic ????...perhaps another member recognizes it?
#4

 Where are you located? That may help narrow down what make and model that set is. Most Majestic sets I've seen have the name stamped right into the dial escutcheon, they also have a plate on the back of the chassis that says "Majestic" Grigsby-Grunow Inc, Chicago, or in Canada "Majestic" Standard Radio Manufacturing. LTD., Toronto or alternatively  "Majestic" Rogers-Majestic Corporation, LTD, Toronto.
  However Majestic brand radios were not the only ones that look like this, at least in Canada, I've seen Rogers sets that are almost identical to the Majestic ones except for the name "Rogers Batteryless" being stamped on the escutcheon. I have also seen Canadian Marconi and Canadian Westinghouse sets that have a very similar design. One thing that may hep is if you could post a photo of the set from the rear, or even of the chassis itself. It is definitely not a Philco though, Canadian or American.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5308 online users. [Complete List]
» 2 Member(s) | 5306 Guest(s)
AvatarAvatar

>