Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Eico 470 scope
#1

Hello all,
I'm trying to find the schematic for the Eico 470 oscilloscope, if anyone would be kind enough. The unit I'm restoring has a burn out power supply. I believe this model to be similar to the 425 version which also uses a 5Y3 as the high voltage rectifier.
Regards,
Daniel
#2

Hi Dan and welcome to the Phorum!
I can get you a copy of the 425 and the 460 but don't have one for the 470. What voltages are you missing?? Check with the rectifiers removed!
Terry
#3

Hello Terry,
Thanks for the reply.
I'd really like to get the diagram to verify the power transformer filament line up and the power supply section. The 425 has the same tube high voltage rectifier as mine ( the 470 ), while the 460 has an 1V2. So I think my wiring diagram ( at least for the power supply section ) is quite similar. Before I put in a replacement power transformer and power things up, I would like to make sure !

Its surprising that the 5y3 high voltage rectifier even worked as they were used probably at their very maximum voltage specification.

Regards,
Daniel
#4

So why not check the AC voltages on the plate or plates of the rectifiers?? Hv and lo voltage without the tube out so if there is a shorted cap down the line it don't be an issue.
Terry




Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>