Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Signal generator
#1

I have an Eico 315. It has been all recapped and properly calibrated (hopefully), but still occasionally drives me insane, especially when on the higher frequencies.All that long wait untill it stabilizes.... Long story short, I am looking at BK 2050.Any opinions on that one? I believe it is a solid state. Shouldn't it be more stable and reliable? Thanks.
#2

If I were ot splurge I'd get me a synthesizer type one, so it is 1) dead on the money and 2) no need to use a counter.

PS. Careful with solid state gens, when plugging them, even via a cap, to a plate circuit. Will take the output out.
#3

I usually leave my old Eico on for at least a half hour before using it, and still have to "fine tune" whilt connected to a frequency counter. Incidently little handheld frequency counters can be had for very little money nowadays.
#4

I have a good quality table top frequency counter. How would I know otherwise my generator's instability?
#5

If you have a digital synth gen, for your purposes (radio alignment) instability is not important.
After all, how do you know your counter instability? Who is watching the watcher?




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 5873 online users. [Complete List]
» 1 Member(s) | 5872 Guest(s)
Avatar

>