1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
ok to strip?
TimC
☆
****
Posts: 262
Threads: 27
Joined: Jan 2010
City: Rochester, NY
#1

10-27-2014, 04:53 PM
Dumb question, but I'll ask anyhow

I have what I think is a 52 cathedral.
Some jackass thought the cabinet needed improvement..
Want to see if these were photophinish at all.
Too early a radio for photophinish I think.

Tim
(This post was last modified: 10-27-2014, 04:57 PM by TimC.)
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#2

10-27-2014, 05:10 PM
Nope, no photofinish on a 51B...
--
Ron Ramirez
Ferdinand IN
Find
jerryhawthorne
Phorum Expert
*****
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
#3

10-27-2014, 06:14 PM
Great news from Ron. That radio can be saved with a lot of stripping and refinish. Nice looking little cathedral.
Jerry
A friend in need is a pest!  Bill Slee ca 1970.
Find
Arran
Phorum Expert
*****
Posts: 4,816
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
#4

10-27-2014, 09:38 PM
 One more thing though, use proper paint and varnish remover to strip the cabinet, lacquer thinner and acetone are not going to cut it this time. However the lacquer thinner and acetone are good from removing residue after you get the paint off. It looks like someone in the 1950s or 60s had a go at "Antiqueing" this poor model 52, that was the decorating trend of doubtful taste from that time, tackiness didn't begin in the 1970s you know.
Regards
Arran
Find
« Next Oldest | Next Newest »
Thread Closed




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Restore Code ??
Can someone tell me if my 42 tubes are connected triode or pentode in fixed or cathode bias? How could I tell by looking...dconant — 10:47 AM
Philco 40-120C Restoration
Hello David, that is great news about the tubes source being local ! Sounds like you got good start on the radio . ...radiorich — 09:41 AM
An attempt to remove the Field Coil from a G speaker
Mike; I've only run into a speaker with an open filed coil twice, and they were on newer speakers from the 1940s. One ...Arran — 12:48 AM
An attempt to remove the Field Coil from a G speaker
Arran Yes, this is my plan for now and what do I got to lose, this is not even the speaker from this radio, but one o...morzh — 10:44 PM
An attempt to remove the Field Coil from a G speaker
Mike;  I would unwrap the field coil, and see if maybe there a break near one of the ends, like where the coil wire att...Arran — 10:23 PM
An attempt to remove the Field Coil from a G speaker
...and this is what I did. I fed a little LT into the screwholes with a small brush, and a little on the rim next to the...morzh — 09:52 PM
Philco 40-120C Restoration
I combined the two 40-120C threads together as we like to keep the discussion of the same radio together. It helps with...klondike98 — 09:36 PM
Philco 40-120C Weak, Distorted Ouput
Just checked were I buy tubes price is four dollars. So living in Florid we have a local source for tubes. David    David — 09:14 PM
Philco 40-120C Weak, Distorted Ouput
The higher voltage may be due to higher mains voltage. My mains run 120-125AC when the set was new mains would be 110-11...David — 09:09 PM
Philco 40-120C Weak, Distorted Ouput
Thank you for your reply. I pulled a speaker from a Philco 41-221 and received the same result. I used a signal tracer t...bluecap — 08:45 PM

[-]
Who's Online
There are currently 3989 online users. [Complete List]
» 1 Member(s) | 3988 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration