Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Kadette 77 from 1936
#1

Not a special radio by any means. With 7 tubes, counting the ballast, it is a good example of the tube count inflation that the maker was known for. In this case the use of two  43s to drive that little 5 inch speaker was probably a waste. Yet I would rather have ample audio than two or three ballast tubes.

The new speaker cone helps the audio a lot.

[attachment=5885]

The chassis was in good shape. I don't think anyone had ever worked on it. So it got the caps all restuffed and some new rubber wire. All of the tubes except the rectifier were Kenrads, which were probably original.

[attachment=5886]

The cabinet had been smashed in shipping. Now that is something new!

[attachment=5888]

It works pretty good and makes a nice display companion to our Kadette 66 from the same year.

Yeah, it needs a knob.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#2

If this is the chassis after restoration, it looks like factory, as if no one touched it.
My hat's off to you, Russ.
#3

Yes it is. Notice the new cloth covered wire coming out of the filter cap box.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#4

......




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 1730 online users. [Complete List]
» 1 Member(s) | 1729 Guest(s)
Avatar

>