Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My new A52CK
#1

Got this today finally! An A52CK Philco clock radio.

The guy said restored but geeze [Image: http://www.antiqueradios.com/forums/imag...lleyes.gif] 

Stripping it 98%, leaving spots of original lacquer on it and then painting brown paint with a small brush around the darker toned areas is not restoration........

Will have to redo in the spring. I still love it and thanks again Jim.  Icon_shh


Kirk


Attached Files Image(s)
       

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#2

Good looking radio Kirk. With your talent I'm sure it will be done right.
#3

Kirk;
  I knew what it would be like the first time you posted a link to that auction, a typical "antique mall" style restoration, or what I call a "strip n' clearcoat" job, there are a few of those sorts of radios on my nearby craigslist sites. If you know what to look for it's very difficult for them to hide, no toners, a flat lifeless look, pits from open grain.
Regards
Arran
#4

When I spotted the radio I reasoned ..not a horrible starting point...and a not so easy model to find.
Id rather find them absent toner than colored incorrectly so at least I can see the veneer I have to work with and in this case all the wood looks good and solid without any surprises as opposed to buried with toner or even worse...stained. Work some cabinet magic on this and it will be really pretty. I also like this version of the model better than the other
http://radioattic.com/item.htm?radio=0150114
#5

I just died!!!!!!

There are 2!!!! versions!!!!

Icon_e_surprised Icon_e_surprised Icon_e_surprised

Now I am back on the hunt  Icon_lolno  Icon_lol 

Thanks a lot Jim,  Icon_mrgreen

Kirk

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>