Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-1012 question
#1

Morning folks.
I just cleaned up a 42-1012 and the cabinet looks great. I am in the need for a source on the faceplate, buttons and knobs. Being new to this game I don't have much of an idea where to start looking and any help would be grand.
Thanks in advance.
Shepard
#2

Hi

A good source for the buttons and knobs is Old-Time Replications.

http://www.antiqueradioknobs.com/

As for the escutcheon, I'm afraid you are out of luck. No one reproduces that escutcheon, and it is highly unlikely that anyone ever will. It simply isn't in enough demand for anyone to justify reproducing it.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron for your help on the knobs and buttons. Any idea where I might be able to purchase a faceplate?
Shep
#4

Sorry, no...your only hope is a junk set at this point, or find someone who has junked a 1942 Philco console with a 10-pushbutton escutcheon. And even that will probably be warped, thanks to the lousy Tenite plastic Philco used in 1941-42.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5134 online users. [Complete List]
» 2 Member(s) | 5132 Guest(s)
AvatarAvatar

>