1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
AK808A
morzh
Odobenus rosmarus
*****
Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#61

12-19-2014, 11:35 PM
Edison....never worked one one.
Then again, I never worked on a heck of a whole lot.
Mostly Philcos.
Well, they are not that different after all....except for AK usin 58 tubes everywhere, same thing...
Find
sam
Phorum Expert
*****
Posts: 2,572
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
#62

12-19-2014, 11:48 PM
mike
come on don`t be so modest we seen the stuff kirk gives you Icon_crazy
you moving after new year ?
hey thought for ya  kirk can make a bed in you new garage
sam
Find
morzh
Odobenus rosmarus
*****
Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#63

12-20-2014, 12:39 AM
I have a pool table there...and a sauna. And there is a dedicated beer fridge. Huh? Oh, and a bar stand too.
(This post was last modified: 12-20-2014, 11:59 AM by morzh.)
Find
Arran
Phorum Expert
*****
Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#64

12-20-2014, 02:42 AM
(12-19-2014, 11:01 PM)mafiamen2 Wrote:  good job mike can`t wait to hear it in your new place   Icon_clap Icon_clap
p.s. I have an Edison radio for you to work on Icon_thumbup

 Edison radios don't appear to be anything exotic, Edison bought out Splitdorf around 1927-28 (and overpaid for the company) after the old man retired and the son took over. From what I can see they are pretty much your standard TRF circuit with typical late 1920s and early 30s AC tubes.
Regards
Arran
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6061 online users. [Complete List]
» 4 Member(s) | 6057 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)