Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 112 Highboy
#1

I am looking at a Philco 112 Highboy. It's unrestored. The veneer is in good shape with a few scratches. It is one of the cabinets that Bel Geddes designed. Still has the label on the back of the cabinet. The owner is asking $195 which to me is high. What do you believe would be a fair price? I am out in the Portland OR area. Any feedback would be welcome. Thanks
#2

http://www.philcoradio.com/phorum/showth...p?tid=6087

One of the buys, $99, in 2013.

I say not above 130.

I bought a 111 a year and a half ago which shares the same chassis but is a highboy. $75.
#3

(02-14-2015, 10:32 PM)Umorzh Wrote:  http://www.philcoradio.com/phorum/showth...p?tid=6087

One of the buys, $99, in 2013.

I say not above 130.

I bought a 111 a year and a half ago which shares the same chassis but is a highboy. $75.

Thank you I appreciate the link and the feedback.
#4

Roy, too bad your not closer to AZ. I have a 112 restored I will be listing when I get back there. They are nice radios but I really don't want to worry about shipping them!
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#5

 I would say that $195 is way too much money for the majority of unrestored early 30's consoles. I say this because of where the market has gone not because I don't like them. Where I am, in which they are not nearly as common as the U.S midwest, anything over about $125 makes them a hard sell, and that's in good original condition. Almost all have just the single AM broadcast band, which ends at just over 1500 KC, it wasn't until 1932-33 that sets with a "police band" and shortwave became common. The other reason is because of the styling, even with the Norman Bel Geddes cabinets they are viewed as being old fashioned, and the dials and control panels are all sort of similar. It's a shame in one way in that they are not as appreciated, but then again that also makes them more affordable to those of us that like them.
Regards
Arran
#6

Difference is a questionable dinner for two and a few gallons of gas, so if you want a project take it.
#7

Unless stated otherwise, I found that all craigslist listings are negotiable.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM
two videos to watch VHS and history of TV
Hello Every, Here are a couple videos right up my alley VHS and the history of Television . history of VCR VHS Hi...radiorich — 02:13 PM
Made mistake & did not label connection
You haven't given us the model number of the set so I looked up the 6A8 pin assignment. Pin 8 is the cathode and pin 7 i...RodB — 01:19 PM
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help.  I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM

[-]
Who's Online
There are currently 6051 online users. [Complete List]
» 1 Member(s) | 6050 Guest(s)
Avatar

>