Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Volume control for Philco 65
#1

Where is this in the schematic/circuit? I'm looking at the schematic trying to find it so I can try to help someone out with a problem (volume control is running hot?), but I don't even see a volume control in the schematic at all.
#2

http://www.nostalgiaair.org/PagesByModel...013823.pdf  

Has to be the item that is labelled #1 (listed as 10,000 ohms on the first page) doesn't it??  Just drawn funny, as though the wiper is at the high ohm end of the pot?  
#3

http://www.philcoradio.com/tech/images/65.jpg

Part (25), 1,750 ohms. It controls the screen grid voltage of the two 224 RF amps.

--
Ron Ramirez
Ferdinand IN
#4

ooops... Icon_redface
thanks Ron!
#5

Thanks. I did find it after I posted this.. it's just in a very odd spot on the schematic so I didn't find it right away.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
I can't remember, but there was a particular product for loosening glue on the more modern "spiders", used pos...MrFixr55 — 09:43 PM
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM

[-]
Who's Online
There are currently 1785 online users. [Complete List]
» 3 Member(s) | 1782 Guest(s)
AvatarAvatarAvatar

>