Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 81 -1933 early --Speaker Grill cloth
#1

 Ok,,were can I get Speaker Grill cloth,,,,I have a original piece that was on there,,,,it looks, close to the Small Herringbone Weave cloth,,,that Richmond Design Inc. has,,,but,,that is not it . Is there someone else out there, whom may have what I looking for. Thank You for all you help and time,,,,Ken
#2

Do you have a picture of it?
#3

Kenneth's cloth may be your best option I think. Check RadioDaze and there are some other folks that sell on ebay you can check.
#4

I think Kenny's Small Herringbone pattern looks fine and I would not hesitate to use it in any of my sets which originally had that pattern.

You have to keep in mind that Radio Grille Cloth Headquarters is gone, out of business...and they won't be back...and we will probably never have such a large selection of cloth patterns available to us ever again.

--
Ron Ramirez
Ferdinand IN
#5

  Well,,Thank you all for the input ,,,,,I will have to go with what Mr. Ron,,says,,,,,I had to hear it from the most educated one's on this subject,,,,Thank You all Again




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

[-]
Who's Online
There are currently no members online.

>