Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Power supply for 37-33
#1

Will the ARBE-III http://www.radiolaguy.com/RadioPowerSupply.htm work for my 37-33?  I can't be certain based on the information I have read so far, so I am taking the lazy way out and just asking.
#2

kl
yes arblll should work
sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#3

(06-26-2015, 11:03 AM)sam Wrote:  kl
yes arblll should work
sam

Thanks Sam!  I had both the cathedral and the floor model and sold the cathedral on ebay (mistake).  But I would like to have the console working. 
#4

Welcome to the Phorum!! Icon_wave
#5

(06-26-2015, 02:01 PM)klondike98 Wrote:  Welcome to the Phorum!!  Icon_wave

Thanks Bob.   I have corresponded with Ron for years but never signed on the Phorum.   Several of the 37 philcos in the gallery are mine.  
#6

Not sure if it will. The 37-33 requires two bias voltages  -3 and -9v. It's simple enough to wire up a battery or two for these voltages. Then all you need is +135v, 90v, and 2v for the filaments. Be sure to throttle back the filament voltage if you have been using the p/s on a set with 01A's.

Terry
ps After looking at the link it should work fine!!!
#7

(06-29-2015, 06:24 AM)Radioroslyn Wrote:  Not sure if it will. The 37-33 requires two bias voltages  -3 and -9v. It's simple enough to wire up a battery or two for these voltages. Then all you need is +135v, 90v, and 2v for the filaments. Be sure to throttle back the filament voltage if you have been using the p/s on a set with 01A's.

Terry
ps After looking at the link it should work fine!!!
Thanks!  I had already ordered it.  I know I could rig it but I am getting lazy in my old age.
#8

It's a good playing set . I've got the table model picked it up 30yrs ago. Was in ruff shape and was missing the spkr. Used an 8"pm  spkr w/a p/p output transformer.

Terry
#9

(06-29-2015, 02:44 PM)Radioroslyn Wrote:  It's a good playing set . I've got the table model picked it up 30yrs ago. Was in ruff shape and was missing the spkr. Used an 8"pm  spkr w/a p/p output transformer.

Terry
Terry,

 
I had both the cathedral and floor models of the 37-33 and decided to part with the cathedral as the cabinet is the same as several other models I have on display.  BUT  it sold for less than $30 on ebay and it was in excellent condition.  
KLB




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
I can't remember, but there was a particular product for loosening glue on the more modern "spiders", used pos...MrFixr55 — 09:43 PM
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM

[-]
Who's Online
There are currently 1798 online users. [Complete List]
» 3 Member(s) | 1795 Guest(s)
AvatarAvatarAvatar

>