1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
What type veneer for 41-280?
Edisla
Member
***
Posts: 155
Threads: 25
Joined: Sep 2014
City: Folsom, CA
#1

07-08-2015, 09:31 PM
I was looking at my sheet of walnut but it doesn't look quite the same. My sheet looks like it has more defined lines than the 41-280.

Maybe its just me Icon_smile
Find
Fred Taylor
Phorum Expert
*****
Posts: 765
Threads: 147
Joined: Aug 2012
City: Dallas, TX
#2

07-08-2015, 11:30 PM
Lets see a few pictures of what you got going on. Its ether mahogany or walnut is my guess, there is a lot of photo finish on that set which is fake wood grain and if your trying to match that you cant.
(This post was last modified: 07-08-2015, 11:38 PM by Fred Taylor.)
Find
Edisla
Member
***
Posts: 155
Threads: 25
Joined: Sep 2014
City: Folsom, CA
#3

07-09-2015, 12:15 AM
Only photo finish I can tell are on the front colums.

Here is a pic of side and veneer I have. Maybe it is to close of a shot???

[Image: http://i1289.photobucket.com/albums/b519...5cqpgh.jpg]
Find
Arran
Phorum Expert
*****
Posts: 4,707
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#4

07-09-2015, 05:27 AM
(07-09-2015, 12:15 AM)Edisla Wrote:  Only photo finish I can tell are on the front colums.

Here is a pic of side and veneer I have. Maybe it is to close of a shot???

[Image: http://i1289.photobucket.com/albums/b519...5cqpgh.jpg]

It's French Walnut, possibly quarter cut, but that's the species you need to look for.
Regards
Arran
Find
Edisla
Member
***
Posts: 155
Threads: 25
Joined: Sep 2014
City: Folsom, CA
#5

07-09-2015, 11:16 PM
Well pooh I don't have any of that. Time to start looking.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4795 online users. [Complete List]
» 3 Member(s) | 4792 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration