Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Early 30's Brunswick
#1

Are these good radios? I've had a Brunswick crank phonograph for over 40 years and know they had their own record label, but have no knowledge about the quality of their radios. I'm guessing they didn't sell that many in the '30-'31 time frame. Thoughts?
Steve
#2

Some of the Brunswick sets are pretty interesting with features like turret tuning, tone controls that change dial colors, unique cabinet designs, etc. :

[Image: http://i55.tinypic.com/ekj08w.jpg]

[Image: http://i56.tinypic.com/keu1z6.jpg]

Picture credits to Dale Davenport.

I have the same radio in a consolette cabinet (model 12A):

[Image: http://i286.photobucket.com/albums/ll118...ck-12A.jpg]
Picture credit to Bill Smith.

So my answer is yes, depending on the model, Brunswick made some pretty cool radios!

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#3

John,
Yes, I really like the cabinets too! Unusual looking chassis with most of it covered in what looks like aluminum. I'm guessing they weren't one of the biggest radio sellers at that time.....
Steve
#4

So John,
Any potmetal in it?? How do you control the volume??

Terry
#5

Terry, the large outer knob is tuning and the smaller center knob is volume & tone.  CW/CCW for volume and in/out for tone.  As you move the tone in/out the dial changes color... red - yellow - green.

I didn't notice any pot metal, but it has been a long time since I was in mine, but since it still seems to tune OK there may not be any at all.



[Image: http://antiqueradios.com/gallery/main.ph...alNumber=2]

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4375 online users. [Complete List]
» 1 Member(s) | 4374 Guest(s)
Avatar

>