Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

16b and model 20 pwr trans
#16

To be sure there are many 16B tombstones which have the 5 band chassis and which are factory correct this way. They also sold 16L consoles with 5 band chassis as well. You can tell if yours is correct by checking a couple of things. The earlier 16B tombstones have aless angled or peaked top than the later 4 banders. Also, the holes in the front panels are different. The 5 band chassis has a small hole at the tuning knob, as it has a single shaft which pulls in and out for fast and slow tuning. The 4 bander cabinets have a larger hole for the dual coententric knobs. The 5 band chassis in the 16B tombstone always has the 10 inch speaker hard wired to the chassis through the chassis, whereas the console sets used a plug in speaker arrangement.
#17

that settles it then,the chassis is not original,the speaker is not hardwired. no real biggee for me though. the seller is local and i'm familiar with him though not really friends. i emailed him about the "original " statement in the auction not quite being accurate. he refunded me $50 without me asking so i guess i'm o.k. with it,either way this radio is one helluva performer!
phil




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 3434 online users. [Complete List]
» 1 Member(s) | 3433 Guest(s)
Avatar

>