Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-116 off Craigslist
#16

[Image: http://i1319.photobucket.com/albums/t679...y9a9al.jpg]


[Image: http://i1319.photobucket.com/albums/t679...w9hvrg.jpg]

Nearly done with the cabinet. Few more details to finish up. Grill cloth on the two smaller speaker outlets nearly drove over the edge. Looks slightly different depending the angle you see it from. Finally chose one set up, and left it. Waiting on the capacitors to be delivered so I can start on the re-cap. 
#17

Very nice looking. Great job. Good luck with the chassis restore.
#18

Did the 38-116 have a back cover?? I know that some of the older higher end sets had a cover over the spkr section for acoustic. Even with some vent hole at the top for the electronics would think it would get hot in there.

Terry
#19

Just wanted to add, finished the re-cap and it's playing great. I see what all the hype is about. This thing sounds great and the volume, without distortion, is incredible. A new favorite. 
#20

Nice job refinishing the cabinet. We all knew you had it in you! Looks great!
#21

Looks fantastic!

 I just got one and the ONLY good thing about it, is that the finish is already 99% stripped.

Me


Attached Files Image(s)
   

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#22

Kirk where did you find yours?
#23

I got them from Oyster bay Long Island


Kirk

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#24

Kirk,
 Them? How many did you get?
                            Henry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Pa...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM
Philco Model 38-7: what caps & resistors do fail typically?
Hi all, on vacation in Montreal,  a friend of mine showed me a Philco Model 38-7 console radio from the 30ies. Mechan...Musaeum — 07:21 PM
Part numbers to model cross
I looked thru the documents and did not see one. Might have missed it though.Jim Dutridge — 07:16 PM

[-]
Who's Online
There are currently 1125 online users. [Complete List]
» 3 Member(s) | 1122 Guest(s)
AvatarAvatarAvatar

>