Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another Western air Patrol make over
#1

Here's one more for Jim Sargent's collection that I have done for him. This radio is a model 66 and the speaker is mounted in the back of cabinet with the 2 openings in front. That,s right , It was designed like that . You would think the speakers would be in the front of cabinet on each side but are not Icon_eek . This radio has a tuning eye and will look very nice when finished. Very uncommon set Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy Icon_crazy


Attached Files Image(s)
               
#2

Fred, a very nice job on that. Very unusual radio and attractive. I would love to see it assembled when finished with the electronics.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#3

Another fine job by Fred. Looks great especially with the before.

Paul

Tubetalk1
#4

Sweeeet!

Crist




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM

[-]
Who's Online
There are currently 4832 online users. [Complete List]
» 1 Member(s) | 4831 Guest(s)
Avatar

>