Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1947 Crosley Radio/Phono
#1

I just finished a recap on this radio. The radio plays fine, but the Phono plays but has no volume. Dose this mean that the Phono cartridge or the needle is bad? It is an Astatic L-75-A. Dose anyone know if a replacement is available?
Thanks
Bob
#2

You probably have an old crystal cartridge which has gone bad (they all do eventually).

Syl has posted detailed instructions for rebuilding these here on the Phorum:

http://philcoradio.com/phorum/forumdisplay.php?fid=21


--
Ron Ramirez
Ferdinand IN
#3

Hello Ron
Thanks Ron. I looked at Syl's Post on rebuilding a cartridge. He did a nice detailed job. I think I'll give it a shot, I guess I have nothing to lose. I think my first step will be to print the post, that way I can read it over a few times.
Bob
#4

Another source of vintage record players repairs questions :
<!-- w --><a class="postlink" href="http://www.west-techservices.com/" onclick="window.open(this.href);return false;">www.west-techservices.com/</a><!-- w -->
Ive referred several customers to them for needed hard to find parts & services. Icon_wink
#5

Thanks. That is a nice site. I'll bookmark it for future use.
Bob




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6811 online users. [Complete List]
» 2 Member(s) | 6809 Guest(s)
AvatarAvatar

>