Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

zenith table sets, refresh
#1

 Here are two  zenith radios that needed some attention and so I gave them the (deluxe treatment) . Nothing fancy just a simple make over . One of them plays very nice and the other still needs some work to get it up and running but over all they are some good looking radios. I did not try to duplicate the photo finish the one radio although I could have done something with it Icon_eek


Attached Files Image(s)
                   
#2

Fred
They look great now. 
                Henry
#3

Fred I am green with envy  Icon_sick  Icon_sick. Wish I could do that.  Icon_thumbup Icon_thumbup Icon_clap Icon_clap
Joe

Joe Bratcher near Louisville, KY
#4

Very nice Fred. Nice and simple for sure.

Crist
#5

(11-01-2015, 12:56 PM)w4rtc Wrote:  Fred I am green with envy  Icon_sick  Icon_sick. Wish I could do that.  Icon_thumbup Icon_thumbup Icon_clap Icon_clap
Joe

You can with some practice




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3790 online users. [Complete List]
» 3 Member(s) | 3787 Guest(s)
AvatarAvatarAvatar

>