Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1939 Anode converter No.2
#10

 I think that Terry figured out what it is, it's a B+ or anode supply with a dynamotor, probably for military electronic equipment, such as a radio, in a tank or maybe a "portable" base station. It does roughly what a vibrator type power supply does in a car radio, except it produces more voltage and more current, 6 volts goes in from a storage battery, and several hundred volts come out. I see that near the commutator there is a brass plate with some other information on it, that may answer some questions.
Regards
Arran


Messages In This Thread
1939 Anode converter No.2 - by ciaran - 12-05-2015, 06:36 AM
RE: 1939 Anode converter No.2 - by klondike98 - 12-05-2015, 12:34 PM
RE: 1939 Anode converter No.2 - by AI2V - 12-07-2015, 01:22 PM
RE: 1939 Anode converter No.2 - by ciaran - 12-08-2015, 05:18 PM
RE: 1939 Anode converter No.2 - by Radioroslyn - 12-08-2015, 08:44 PM
RE: 1939 Anode converter No.2 - by klondike98 - 12-08-2015, 10:01 PM
RE: 1939 Anode converter No.2 - by ciaran - 12-10-2015, 01:07 PM
RE: 1939 Anode converter No.2 - by codefox1 - 12-10-2015, 03:18 PM
RE: 1939 Anode converter No.2 - by klondike98 - 12-10-2015, 05:53 PM
RE: 1939 Anode converter No.2 - by Arran - 12-11-2015, 01:44 AM
RE: 1939 Anode converter No.2 - by ciaran - 12-11-2015, 06:33 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5134 online users. [Complete List]
» 1 Member(s) | 5133 Guest(s)
Avatar

>