Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Next 38-690 question
#1

I just removed the cap/tar box , part # 108,  located under the bass/AC switch at the front of the receiver chassis. I carefully noted the location of the 3 wires. Now that I'm ready to re-stuff the box with two .1s and a .7, looking at the schematic for guidance, I'm confused. On the chassis, the ORANGE and the WHITE-BLK-TR wires go to the same lug and the BROWN wire goes to another lug. At first this made sense, but why aren't the ORANGE and the WHITE-BLK-TR just one wire? In other words, why aren't there just 2 wires coming out of the box?

[img][Image: http://i191.photobucket.com/albums/z309/...u5mxu.jpeg][/img]


Messages In This Thread
38-690 wiring question - by DKinYORKpa - 12-20-2015, 02:39 PM
RE: Next 38-690 question - by klondike98 - 12-28-2015, 10:07 PM
RE: Next 38-690 question - by Ron Ramirez - 12-29-2015, 05:52 AM
RE: Next 38-690 question - by DKinYORKpa - 12-29-2015, 10:52 AM
RE: Next 38-690 question - by Radioroslyn - 12-31-2015, 08:02 PM
RE: Next 38-690 question - by Ron Ramirez - 12-31-2015, 11:10 PM
RE: Next 38-690 question - by DKinYORKpa - 01-01-2016, 09:25 AM
RE: 38-690 wiring question - by Phlogiston - 12-20-2015, 03:18 PM
RE: 38-690 wiring question - by DKinYORKpa - 12-20-2015, 03:36 PM
RE: 38-690 wiring question - by DKinYORKpa - 12-20-2015, 03:44 PM
RE: 38-690 wiring question - by SteveJB - 12-22-2015, 10:02 PM
Next 38-690 question - by DKinYORKpa - 12-24-2015, 12:11 PM
RE: Next 38-690 question - by morzh - 12-24-2015, 06:09 PM
RE: Next 38-690 question - by Radioroslyn - 12-24-2015, 07:00 PM
RE: Next 38-690 question - by DKinYORKpa - 12-27-2015, 05:23 PM
38-690 SW bands - by DKinYORKpa - 12-28-2015, 06:23 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3884 online users. [Complete List]
» 1 Member(s) | 3883 Guest(s)
Avatar

>