Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 12s-265 console
#7

 Like all brand Z AC operated models from the late 1930s and early 1940s it would be best to test out the power transformer first before buying, so bring your Ohmmeter and Ohm out the transformer windings at the rectifier tube socket. Brand Z had a nasty habit of using the same size power transformer in a 12 tube set that Philco would have used in a 7 or 8 tuber, it does not mean that they will all burn up but it does mean that there isn't much room for failure either if the set was powered up and run with leaky caps in it not to mention a dead short.
Regards
Arran


Messages In This Thread
Zenith 12s-265 console - by PhilcoJohn - 12-22-2015, 08:34 PM
RE: Zenith 12s-265 console - by morzh - 12-22-2015, 09:56 PM
RE: Zenith 12s-265 console - by Fred Taylor - 12-22-2015, 10:58 PM
RE: Zenith 12s-265 console - by Eliot Ness - 12-22-2015, 11:04 PM
RE: Zenith 12s-265 console - by Fred Taylor - 12-22-2015, 11:17 PM
RE: Zenith 12s-265 console - by Eliot Ness - 12-23-2015, 01:46 AM
RE: Zenith 12s-265 console - by Arran - 12-23-2015, 02:33 AM
RE: Zenith 12s-265 console - by TA Forbes - 12-23-2015, 11:01 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>