Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Latest Acquisition - Philco 38-2
#3

Looks like a nice one. You can be sure that it will be a performer; all of those 36-38 Philcos were. (I'll see you on Saturday). Before you go off a cliff on the cabinet finish, clean it well with Go-Jo, and see just what you have. From the pictures, it looks like it never has been abused.

This is one of the models where the ads said: "No Stoop, no squat, no squint"


Messages In This Thread
Latest Acquisition - Philco 38-2 - by etech - 04-21-2009, 04:11 PM
Re: Latest Acquisition - Philco 38-2 - by BDM - 04-21-2009, 09:01 PM
Re: Latest Acquisition - Philco 38-2 - by Doug Houston - 04-21-2009, 09:28 PM
Re: Latest Acquisition - Philco 38-2 - by etech - 04-21-2009, 10:01 PM
Re: Latest Acquisition - Philco 38-2 - by BDM - 04-22-2009, 12:08 AM
Re: Latest Acquisition - Philco 38-2 - by etech - 04-27-2009, 08:31 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently 3171 online users. [Complete List]
» 1 Member(s) | 3170 Guest(s)
Avatar

>